Power Cable Neutral and System Grounding

Installing medium voltage power cables underground comes with its own set of challenges. From an engineering standpoint, there are several factors one needs to consider before installing the cable. The most overlooked if not a well-understood factor is the type of power cable that’s required for the application and when to ground the cable’s neutral …

Power Cable Neutral and System Grounding Read More ยป

Concentric Neutral Cable

Substation SCADA System – Design Guide

For electrical engineers, designing the Supervisory Control and Data Acquisition system (SCADA) for an electrical substation can be a daunting task, if not confusing with the different ways you can connect various Intelligent Electronic Devices (IED’s) based on protocols each device supports. This article serves to help you understand this system so you can design one as well.

Data Concentrators

Cable and Conduit Installation in Substations – Best Practices

Substations contain equipment that are controlled by relays. If the relay is installed at a remote location such as a control house then you need to lay down wires from the relay to the location where the equipment is in the yard. The process of laying wires can be as simple as directly burying them in the ground to pulling them through a conduit. Sometimes cable trenches are used. Site conditions, project funding, and the type of substation (bulk power vs. distribution) dictates which method is the most suitable.

Direct Buried Conduit - PEguru - Power Systems Engineering
Scroll to Top